I love those little hanging jars with tiny flowers in them that you see everywhere. I have some from Matalan but the jars are green and I really wanted clear ones but couldn’t find what I wanted in the shops so decided to make my own. They are super simple so if you fancy making some yourself, here is how I made mine.
First gather up what you will need.
Some small jars
I used three jars on my branch but I’m going to make another one with five on it, just go with whatever makes you happy.
Lay out your branch and jars so that you can see how far below the branch you want the jars to hang. Once you are happy with the spacing cut three pieces of twine, the length of each should be about three times the distance from the jar to the branch.
Tie a small loop in each end of your three pieces of twine. This will involve a bit of trial and error until you get the loops in the right position so that your jar will hang where you want it to, allowing a little extra length to allow for tiring it to the branch. Cut off any excess twine. This is what we will use to hang them from the branch. Cut three smaller pieces of twine to go around the neck of each jar.
Find the middle of your long piece of twine and tie it to the branch, making sure the ends are level. Thread the small piece of twine through the loops on the ends of the long piece of twine and tie tightly round the neck of the jar. Repeat for the other two jars.
Put a little water into each jar and pop in a flower or two. Add a hanging loop made from twine.
You know you have a problem with procrastinating when you realise the fabric you bought and the wooden eggs you painted to make an Easter wreath have been sitting there for a couple of years and you still haven’t got round to making it! That was my reality this morning. I was looking on Instagram and saw a lovely floral wreath made by @justlaurajayne so I decided today was the day the wreath would be made.
I thought maybe some of you would be interested to see how I made it so I’ve put together a tutorial to show you what I did.
First get together all the supplies you will need. I used
a wire wreath frame
burlap ribbon or strips of burlap
a selection of Easter decorations
hot glue gun
a bow, or ribbon/fabric to make a bow
For a 30cm wreath frame you will need about 18-20m of burlap ribbon, depending on how full you want your finished wreath to look. I didn’t have any burlap ribbon but I had quite a bit of burlap fabric so I cut it into 12 strips which were about 1.5m long and 6 inches wide.
Start by folding your burlap in quarters and threading a small length of garden wire through it and twisting to secure it. Then use the wire to attach the burlap to one of the spokes of the frame.
Begin pulling loops of the burlap up through the outer ring on the wreath frame. Next pull a loop up through the middle ring and then through inner ring.
Once you have done these three loops, twist the burlap firmly and work your way back up the wreath frame in the opposite direction, pulling loops of burlap through each segment in the wire frame. Continue doing this until you have all the frame filled.
Secure the end of the burlap to the wire frame in the same way as you did at the start, by threading garden wire through it and twisting round the frame.
Lay out your Easter decorations on top of the wreath until you are happy with how they look and then glue in place.
Make a bow and glue it to the wreath, add a loop of garden wire on the back as a hanger and Hey Presto, it’s finished!
My wreath is finally hanging proudly on the door and I am off to put the rest of my Easter decorations up.
Happy Easter x